As an Amazon Associate, BuildToolHQ earns from qualifying purchases. Specifications are for guidance only — always verify against the anchor manufacturer's ICC-ES ESR report and local building codes.

Full Specification

Type

Strap Toggle (SNAPTOGGLE)

Diameter

1/4"

Available Lengths

Standard — adjusts to wall thickness

Pilot Hole Diameter

1/2"

Pilot Hole Depth

Through-wall

Embedment Depth

N/A — requires hollow cavity

Recommended Torque

15 in-lbs

Compatible Substrates

Hollow CMU block, Hollow brick, Drywall, Thin panels

Load Rating

270 lbs tension safe working load — Ultimate: 1,080 lbs tension — Ultimate tensile value in hollow concrete block (TOGGLER). Allowable calculated at the manufacturer-stated 4:1 safety factor. — Figure is for hollow concrete block. The widely quoted 265 lbs is the 1/2" DRYWALL rating, not block. Capacity varies with block strength and condition, bolt size, hole diameter, and how far the load sits from the wall.

Material

Polycarbonate strap, Zinc bolt

Removable

Yes

Best For

✓Hollow CMU block
✓Hollow brick
✓TV mounts
✓Shelf brackets in hollow walls

Not For

✗Solid concrete
✗Solid brick or block

How a SNAPTOGGLE Grips

A SnapToggle locks a solid metal channel flat against the back of hollow material, held in place by plastic straps that snap off after setting. Unlike a spring toggle, the channel stays in place if the bolt is removed, making it re-usable in the same hole and stronger for its size.

Installation Tips

1.Best hollow-wall anchor for CMU block — bolt can be removed and replaced

2.Drill a 1/2" hole — much smaller than traditional toggle bolts

3.Snap off the plastic tabs after setting to lock the channel in place

4.Accepts any 1/4-20 bolt — easy to replace if stripped

Frequently Asked Questions

What size drill bit does a 1/4" SNAPTOGGLE need?

Use a 1/2" drill bit, drilled through the wall.

How much weight can a 1/4" SNAPTOGGLE hold?

270 lbs tension safe working load. Actual capacity depends on base material strength and embedment — verify against the manufacturer's ICC-ES ESR data for structural work.

How is a SNAPTOGGLE installed?

Drill through the wall. This anchor grips the back of hollow material rather than the hole itself, so there is no embedment depth to set.

How much should a 1/4" SNAPTOGGLE be torqued?

Tighten to 15 in-lbs. Over-torquing is a common cause of anchor failure.

Can a SNAPTOGGLE be removed after installation?

Yes — this anchor type can be removed after installation.

Free Tool · Built on ACI 318-19

Need something more specific than these standard values?

Get the exact anchor diameter, embedment, and edge distance calculated for your specific load and substrate.

Try the Anchor Spec Engine →

Related Anchor Guides

Molly Bolt vs Toggle Bolt Types of Drywall Anchors How Much Weight Can Anchors Hold?How to Install Concrete Anchors

← Back to all anchor types