Sleeve Anchor
1/2" Sleeve Anchor
1/2" sleeve anchor specs: pilot hole (1/2"), embedment (2" min), torque (35 ft-lbs), 2,400 lbs tension in concrete, brick, and block. Installation guide included.
Diameter
1/2"
Pilot Hole
1/2"
Embedment
2" minimum
Torque
35 ft-lbs
Free Tool \u00b7 ACI 318-19 Compliant
Need this spec\u2019d for your exact load and substrate?
These specs are general reference values. Get the exact anchor diameter, embedment, and edge distance for your specific project.
Try the Anchor Spec Engine →Full Specification
Type
Sleeve Anchor
Diameter
1/2"
Available Lengths
2-3/4", 3-3/4", 5", 6"
Pilot Hole Diameter
1/2"
Pilot Hole Depth
Hole depth = anchor length
Embedment Depth
2" minimum
Recommended Torque
35 ft-lbs
Compatible Substrates
Concrete, Brick, Solid block, Stone
Max Load Rating
2,400 lbs (tension), 3,000 lbs (shear)
Material
Zinc-plated steel, Stainless steel
Removable
No — permanent installation
Best For
- ✓Heavy handrails
- ✓Structural brackets
- ✓Large pipe supports
- ✓Equipment bases on masonry
Not For
- ✗Hollow block
- ✗Thin concrete (under 3-1/2")
- ✗High seismic SDC D-F
Installation Tips
1.Use a rotary hammer for clean 1/2" holes in hard concrete
2.Blow out all dust before inserting — dust prevents full sleeve expansion
3.Preferred over wedge anchors in brick and old concrete that may fracture under wedge expansion
4.Stainless steel versions available for coastal and chemical exposure environments
Where to Buy
As an Amazon Associate, BuildToolHQ earns from qualifying purchases. Specifications are for guidance only \u2014 always verify against the anchor manufacturer's ICC-ES ESR report and local building codes.