Sleeve Anchor
1/4" Sleeve Anchor
1/4" sleeve anchor specs: pilot hole (1/4"), embedment depth, torque (5 ft-lbs), load ratings (450 lbs tension), suitable for concrete, brick, and block.
Diameter
1/4"
Pilot Hole
1/4"
Embedment
1" minimum
Torque
5 ft-lbs
Free Tool \u00b7 ACI 318-19 Compliant
Need this spec\u2019d for your exact load and substrate?
These specs are general reference values. Get the exact anchor diameter, embedment, and edge distance for your specific project.
Try the Anchor Spec Engine →Full Specification
Type
Sleeve Anchor
Diameter
1/4"
Available Lengths
1-1/2", 2", 2-3/4", 3-3/4"
Pilot Hole Diameter
1/4"
Pilot Hole Depth
Hole depth = anchor length
Embedment Depth
1" minimum
Recommended Torque
5 ft-lbs
Compatible Substrates
Concrete, Brick, Solid block, Stone
Max Load Rating
450 lbs (tension), 600 lbs (shear)
Material
Zinc-plated steel, Stainless steel
Removable
No — permanent installation
Best For
- ✓Electrical conduit straps
- ✓Light fixtures
- ✓Signs
- ✓Pipe hangers
Not For
- ✗Hollow block (use toggle bolts)
- ✗Heavy structural loads
- ✗High vibration
Installation Tips
1.Works in both solid and crumbling/old concrete where Tapcons may not thread well
2.Tighten until the sleeve expands fully — you'll feel increased resistance
3.Accepts a standard hex bolt head — versatile for various fixture types
4.Available with hex nut, flat head, or round head configurations
Where to Buy
As an Amazon Associate, BuildToolHQ earns from qualifying purchases. Specifications are for guidance only \u2014 always verify against the anchor manufacturer's ICC-ES ESR report and local building codes.